![]() Reuse or replace injector or injector and solenoid as indicated by testing. Follow procedures supplied with this tool. The Kent-Moore ® POP stand should only be used as a diagnostic tool on fuel injectors that have been removed from an engine. Clean the exterior of the injector with clean solvent and dry it with compressed air.Note: Do not test new or reliabilt ® remanufactured electronic unit injectors prior to installation in the engine.To clean and inspect the injector, complete the following steps: ? ? Inspection of the Electronic Unit Injector On a Series 60 engine EUI, only the injector solenoid and seal rings are serviceable. Remove carbon from the injector exterior in the area where the tip joins the nut, using wire buffing wheel, J 7944. Cover the injector hole in the cylinder head to keep out foreign material. ![]() Lift the injector from its seat in the cylinder head by inserting a pry bar under the injector body.Loosen the injector wire terminal screws two full turns and remove the terminal wires.To remove the injector, complete the following steps: ? To determine if repair is possible or replacement is necessary perform the following procedure.įlowchart for Repair or Replacement of Electronic Unit Injector
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |